Shower room hanging wheel is to install a hardware fittings, shower room glass door is necessary to move the door, the sliding door or what we say at ordinary times, is easy to use, save space, repeatable installation etc, usually in the bathroom, kitchen, balcony, the workshop office, the company has more applications, and move the door hanging wheel is installed in door in one of the most important part.

Move the door hanging wheel including block and tackle, fitting and installation structure, its characteristic is: described the installation structure consists of fixed and moving pieces, set on a chip with chute, move on with the slippery wing together with chute, there are fixed on both ends of the chute of dynamic positioning structure, described in the fitting for the screw, the screw and move at the end of the piece is fixed, the other end connected to the block and tackle the stents. The sliding door is easy to install and disassemble for maintenance.

Move the door hanging round of general can be divided into 2, 4, 6, 8 wheels hanging wheel, in theory the more wheels move the door hanging wheel, use rise more convenient, and when a wheel is broken, the other wheels can continue to work normally, will not affect the use of the door, if only two wheels move the door hanging wheel, once one of the broken, only rely on a wheel can't be used normally, the number of pulleys can choose according to the size and weight of the glass door.

How to install the sliding door pulley:

1. The space between the fixing screws of the lifting rail is 20cm;

2. The hanging rail shall be straight after installation. The top surface of the hanging rail shall be close to the bottom of the door frame.

3. The height and level of the door can be adjusted by the rotation of the connecting screw or the insert plate on the bracket after the sliding door lifting wheel frame is fixed on the door. Generally, 5mm from the ground under the door is preferred;

4. The hidden sliding door shall be 30-60mm wider than the opening;

5, the position of the limit device, the door and the door frame will not collide and the gap is small;

6. The positioner should be on the lateral vertical line of the door.